The FP18 is a 110V 1/8" capacity plasma cutting system with an on board air compressor. Simply plug the unit into a 110 volt outlet and the system will 10 cut gauge, 1/8" mild steel at 9 IPM. No more air compressor to haul around. The internal compressor insures clean, dry air with no need for a filter.

Features:
Operates on standard 115 volt current
Built-in air compressor - Portable & Self Contained!
Cuts mild steel, stainless steel, aluminum, copper or brass
Weighs only 55 lbs!
Features a "pilot-arc" that burns through paint and rust
Drag tip system allows placement in tight spaces and awkward locations
Substantially reduces joint prep time - Warping does not occur and slag removal is not required.
Long consumable life/low cost per cut
Firepower automatic torch restart system
One year Firepower warranty

Comes complete with: 20 ft. genuine Firepower drag torch system, 6 ft. power cord with plug, (5) 1445-0031 cutting tips, (3) 1445-0016 electrodes, (1) 1445-0017 gas distributor, instruction manual.

Specifications:
Input voltage - 115V 60HZ
Input current - 20 Amps
Maximum output - 18 Amps
Rated output - 12 Amps
Rated duty cycle - 30%
Maximum cutting capacity - 1/8"
Cutting speed (mild steel) - 20ga./60" Per Minute, 18ga./60" PM, 10ga./12" PM, 1/8"/9" PM